Mount this carrier board directly to Rapiro, and you can wirelessly control your Rapiro using XBee.

The breakout board for the chip SC16IS750 converts I2C or SPI serial signals to UART. It is handy for expanding a serial port when using microcontrollers.

The Switch Science mbed LPC824 enables you to use NXP LPC824 (ARM Cortex-M0+) with the mbed online compiler.

This carrier board let you use Intel Edison for controlling Rapiro. GPIO input voltage level is converted from Edison’s 1.8 V to 3.3 V.

Intel® Edison Breakout Board

The IC with the built-in countdown timer monitors GPIO of Raspberry Pi, and the software on Raspberry Pi sends pulse signals to GPIO at a fixed interval to re-set the timer in the IC.

It is a connection board to connect JDI reflective memory in pixel (MIP) LCD to FRDM-K64F. Since it supports multiple types of LCD and is assembled with an oscillation circuit etc., by simply connecting it,it is possible to evaluate JDI reflective MIP LCD.

An ESPr Developer semi finished kit with ultra low power consumption color LCD from JDI (Japan Display Inc). The components are fully soldered, so just fix the display to get started!

Ultra-low power consumption color reflective LCD module from JDI (Japan Display Inc.). Introduction of proprietary reflective color technology made it possible for you to enjoy clear visibility even under the direct sunlight. Communication method and size are SPI and 1.28 model respectively.

BME280, the precision sensor from Bosch, is soldered onto PCB. Not only the pressure and the temperature, this sensor can measure humidity. It uses both I2C and SPI (supports 3-, 4-wire SPI) interface.

An ultra small GPS logger which is equipped with GPS, barometer, and 9-axis motion sensors.

This product is only a pcb of ESP-WROOM-02 Breakout Pro.

The IC with the built-in countdown timer monitors GPIO of Raspberry Pi, and the software on Raspberry Pi sends pulse signals to GPIO at a fixed interval to re-set the timer in the IC.

Multi voltage level converter with the Texas Instruments chip, TXS0108E, that performs bidirectional level shifting from any voltage to any voltage between 1.8V and 5V. It allows 8-bit bidirectional low-voltage conversion for a wide range such as 5V-3.3, V3.3V-1.8V, 5V-1.8V.

These are the stand-offs and screw sets for Raspberry Pi. You can secure the HAT with your Raspberry Pi.

Amp board kit for Super directional ultrasonic speaker which delivers sound only straight ahead by ultrasound.

Using ultrasound, the speaker kit sharply directs and sends audio only straight. It has many wave transmitters. Please note that you need to solder many points for assembling it.

LM75B temperature sensor (I2C interface)

This is a T-cobbler breakout board kit designed for extending the GPIO, Serial, SPI and I2C interface on Raspberry Pi A/B to breadboard.

5V to 3.3 V, this is a converter board for breadboard with step-down voltage regulator.